The server has not detected any activity for the last 3 hours.
For your security, your session will expire in 2 minutes and you will be redirected to the Sign In page.
Would you like to stay signed in?
Staub Mercury Inertia Controller measures 4 1/2 inches long and .850 inches in diameter. BreaKO Mercury Reduction System measures 3 inches long by .850 diameter. Very good used condition. $35.00 each.
...Click for more info
Rubber fingergroove grips new in original packaging. Available for S&W K or L frame round butt and Colt short D frame post 1971 square butt. $25.00 per set.
...Click for more info
Most are used and about 95%, a few are new in original packaging. Some include screws. Available for following models only. Remington model 760 & 742. Ruger Mini 14. Ruger Model 77 round top
...Click for more info
4 factory tubes including 2 flush mount, improved cylinder and modified, 1 Accu Steel full for BB, 1, and 2 shot, and 1 extended extra full turkey .670". Also includes wrench. These tubes that al
...Click for more info
Three tubes including 1 improved cylinder, 1 modified, and 1 ported extended extra full. Nice used condition in original storage tubes. All for $25.00.
...Click for more info
All steel 1 inch medium height ring set. Standard rear and extended front. Excellent used condition. Also shown is a set of extension front and rear. Price is $29.00 per set.
...Click for more info
All steel 2 piece bases #45157 and medium height rings #45338. All in matte silver finish for one inch scope. New in original packaging.
...Click for more info
Fully adjustable rear sight assembly for very early K frame revolvers before the numbered models with 1.74 inch center to center hole spacing. Will not fit later guns with 1.82 inch hole spacing. Look
...Click for more info
Fits dovetails on Sako rifle actions. All steel with nylon bushings to hold scope tight and protect finish. One inch matte finish. Excellent used condition.
...Click for more info
.22 Long Rifle 4 1/2 inch barrel with Truglo electronic red dot scope installed on Weaver type base. Excellent bore. Comes with barrel guide pin and original front sight. Recently reblued with some ve
...Click for more info
This base will attach to the factory Ruger scope mount slots and convert to accept any Weaver style rings.This scope mount fits ALL HUNTER MODELS including the Single Six Hunter. This scope mount fits
...Click for more info
Non checkered walnut target grips for Ruger Blackhawk, Single Six, and early Model Vaquero. Comes with screw. Small chip at rear butt left panel shown in photo.
...Click for more info
Rubber wrap around grips for Ruger .22 Auto Standard and Mark 1, A 100 frame with 2 9/16 inch center to center hole spacing. Not for the very early Mark 1's with A 54 frame and not for Mark II and lat
...Click for more info
Black #8304 1 size 4 for medium and large frame double action revolvers with 7 to 8 1/2 inch barrels and single action revolvers with 6 to 7 1/2 inch barrels. Excellent used condition.
...Click for more info
Black Hogue rubber forend and black Choate synthetic stock with sling swivel and recoil pad. Comes with attaching bolt. Nice used condition.
...Click for more info
Factory checkered walnut forend for 20 ga. with takedown bolt. about 85% finish with small solid repaired crack on right side at front.
...Click for more info
Factory 12 ga. walnut flat bottom forends. 6 7/8 inches long with 14 grooves. One has the cutout for action bar at the nine o'clock position the other about eleven o'clock. Both near 95% original fini
...Click for more info