 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Springfield - Garand M-1
Guns International #: 100880812 Seller's Inventory #: 70117A
Category: Military Rifles - M1 Garand - Springfield Rifles - M1 Garand
Seller's Information
When emailing or calling sellers direct, please mention that you saw their listing on GunsInternational.com
Seller: Jim's Classic Guns
Company: Jims Classic Guns
Member Since: 12/22/12
First Name: James
Last Name: Trometer
State: Kansas
Zip: 66210
Country: United States
Phone: (913) 961-4080
Fax:
Number of Active Listings: 30
Seller: Private Seller
Return Policy: 3 day inspection and return policy on used guns.
*Guns that are shipped to an FFL must be inspected on the FFL's premises. Some guns per mutual agreement may be purchased AS IS.
Payment Types Accepted: MO, Cashiers Check, or Personal, Company Check
About Us: Returns may encounter a discretionary return fee, if necessary.
Description:
Sales Pending !
Collector's Choice - This Garand 689XXX was produced in June of 1942 w/all of the correct parts.. The wood is a uniform stain reddish walnut throughout w/ minnimum wear and the correct flat lower band. The hand guard band is a grooved cast band (see pic) and wasn't changed until late '42 or early '43 (see Scott Duff The M-1 Gar...), The stock frrule has the the corerect hole in the bottom.
The receiver is a olive tone and consistant with the bolt the follower rod is a a darker w/similiar tones to the arm follower and
arm assembly. See inventory of all parts to follow.
Serial No. 689XXX, Date of Mfg. 6/42, receiver Dwg No. D28291 17 w/HT # 01A & diamond, Barrel Side markings S-A-6-42 (Upsidedown), Bolt Dwg No. D28287 12SA w/HT Lot # A8W,, Operating Rod Mfg No. D35382 3SA (See pic), Trigger Hsg Dwg No. D28290 5 SA Hsg has correct cloverleaf hole in side) w/ Milled trigger Guard, Bullet Guide T2B (Forged), Clip Latch is Rounded, Trig Hsg Parts - hammer C46008 - 2SA, Safety D46015-SA, Trigger - w/sm;l hole, Plunger - w'Guide Wings, Spring
Hammer Hsg - Std throughout war.
Follower Asby - NPN, Follower Arm T-3, Follower Rod - Short Fork Riveted (See Pic), Lower Band - Flat (Forged), Rear
Hand Guard Clip - Forged w/Groove (See Pic),, Butt Plate - Correct w/Trap Door, Stock - Correct cartouche "SA/EMcF,
w/proper square framing and encircled "Cannon Cartouche" 3/4" to the right, Stock Ferrule T-2 w/hole, The "P" encircled
is located at the inside of the pistol grip whoch was mandatory which indicated that this firarm passed the firing test, Gas Cylinder - This one ha the narrow platform (.540) or 9/16, TGas Cyl Lock -T-1 w/Chamfered edge, Gas Cyl Screw - Single
Slot, Front sight - .640", Rear Sight - Lock 2A w/Rd edge, Aperture Mfg. Spg Square T3
SOLD