The server has not detected any activity for the last 3 hours.
For your security, your session will expire in 2 minutes and you will be redirected to the Sign In page.
Would you like to stay signed in?
IBM used Fabricated type 4 trigger housings for there final 2 production runs starting at serial #3,651,520 to end of production 12/43. Stamped BE B. Blueing is intact no significant wear or scratchs
...Click for more info
This an IBM type 3 round bolt. Bolt is stamped AOB. Both Firing pin and extractor are stamped WB. Ejector is type 1. IBM only used type 1 ejectors throughout production. Photos clearly show stam
...Click for more info
This is amilled Tpe 2 sight Marked "HI" for Inland Division.Sight is is in excellent condition. No dings or scratches, Parkerizing is excellent. See Photos.
...Click for more info
These recoil plates were used as replacement parts. Manufactured by Prescion Instruments Company also known as Wadco. These can be found on any manufacturers Rifles. Was used in WW2 late 1943 to end o
...Click for more info
This recoil Plate is in excellent to NOS. This type 2 was used by inland for early manufacturing runs Parkerization is excellent and no sign that it was ever installed. Used in serial# range 100
...Click for more info
Early Type 1 Inland Trigger housing. This housing is correct for serial # range 100 90,000. Produced between April 1942 and November 1942. This is an extremely rare item. It is milled and has been rep
...Click for more info
This operating slide is for serial # range 1,982,520 2,352,519. Rifle produced April 1943 May 1944. Last serial number block of Standard products production. Excellent to New condition shows no signs
...Click for more info
This is an early serial number Butt plate. Serial range #100 260,000. Diagonal pattern properly Identified with comprehensive guide. Good Condition.
...Click for more info
This a late production Inland butt plate in good condition. Parkerizing is gone on outside, but no rust and 2 or 3 small dings. Correct for Inland Serial # 260,000
end of production.
...Click for more info
15 rd Magazine for Standard Products M1 Carbine. Stamped "SS". Good to excellent condition minor wear of blueing. Magazine was disassembled then cleaned, lubed, and treated with rust prevent
...Click for more info
WW2 Magazine .30 caliber for M1 Carbine stamped (AI). Magazine is in excellent condition showing little to no wear at all. Magazine disassembled, cleaned, lubed, and rust preventative applied.
...Click for more info
These are authentic WW2 M1 CCarbine .30 caliber 15 rd Magazines. Both are stamped for authenticity. One is "LU" and one is stamped "U" for Underwood. As seen in photos both o
...Click for more info